The glass cleaning machine is a device that cleans the glass surface quickly and efficiently. According to incomplete statistics of market data, glass deep processing manufacturers encounter large and small problems in the process of using the glass cleaning machine, resulting in low processing efficiency, coordination of costs and increased consumption of raw materials, which is not conducive to the healthy development of the enterprise.
The full name of the glass cleaning machine is actually the horizontal glass cleaning and drying machine. The first stage is to use water and brush to clean the glass. The second stage is to pass through the sponge roller to absorb the water droplets on the glass. The next step is to use the air knife connected to the fan to dry both sides of the glass. Generally speaking, there is a heating rod at the inlet of the fan to ensure that the incoming air is hot air, which is helpful for drying the glass. Then, the air drying system of the glass cleaning machine is clear. The heating rod at the inlet of the fan goes to the fan and then to the air knife to blow out the air.
In the air drying system, the heating rod is prone to failure, because the heating wire inside the heating rod is easy to burn. How can the heating rod avoid damage? It is necessary to cut off the transmission of the glass washer, the water pump and other working elements when shutting down the machine. After the wind heating is stopped, the fan will continue to work for 10 to 20 minutes and then shut down. This can help the heating rod to dissipate heat and protect the heating wire of the heating rod.
In this way, it is very simple to ensure the air drying system of the glass washer, that is, to protect the heating rod and the heating wire. How to operate it is to stop the air heating, and then turn off the fan for 10 to 20 minutes.
During the use of the glass cleaning machine, it is easy to get stuck in the glass conveying, burst the edge, scratch, wash unclean, blow dry and other phenomena. According to the information fed back by the cleaning machine manufacturer's maintenance technology, basically all the failures are caused by the nonstandard implementation of the operating procedures, and the maintenance and repair of daily equipment accessories are not in place. Therefore, professional training is imminent.